The new Marposs hardness measuring fork has been conceived for an easier and more friendly use on the shop floor environment. Its wide inspection range allows testing all the crankshaft’s families without any kind of mechanical tooling, thus completing the HRC inspection of all pins and journals within few minutes.

Follow the link to get more information about the: Conventional Rockwell Hardness Testing Equipment for Shaft Like Parts

The system is capable of verifying the surface hardness of Crankshafts and Camshafts, in Rockwell scale, quickly and very reliably. Tests can be performed on either finished ground surfaces or on turned and facetted surfaces, allowing for testing immediately after the heat treatment operation.

The hardness tests are performed according to ISO standards.
The uniqueness of this testing system makes it possible to neglect the test parts machined surface condition when the required testing load is applied to it. As a result the system can provide a higher level performance in terms of precision and reliability.

To know more log on to the: Conventional Hardness Rockwell Testing Equipment for Shafts